Ill probably add to / edit this blog as I continue to test & install more displays.
This is an attempt to archive info & notes from myself and others about different displays used. The displays in these radios havent been supported by Icom in several years. But I have discovered on 6 meters, with 1 kW power from a PA to a 7 element Yagi antenna, when pointing the antenna in the direction to the shack, my strong transmitted 50 MHz signal is. item 2 ICOM IC-756 HF 6 Six Meter Transceiver C MY OTHER HAM RADIO GEAR ON EBAY 2 - ICOM IC-756 HF 6 Six Meter Transceiver C MY OTHER HAM RADIO GEAR ON EBAY. The seller is “everett287l” and is located in Oak Park, Michigan. This blog is about replacing the LCD display in a Icom IC-756 classic. I am using Icom IC-756PRO3 with WSJT-X (now using Version 2.5.0-rc1) without any important problems with the WSJT-X (but see one problem reported below). item 1 Icom Ic-756 Pro II with PS-125 PS 1 - Icom Ic-756 Pro II with PS-125 PS. This item is in the category “Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Transceivers”. The item “ICOM IC 756 Pro II” is in sale since Saturday, June 18, 2016. See pictures to view various features on this unit.
Operate HF or 50 Mhz with complete confidence. This unit is in excellent condition, all features fully operational. Unit also has four (4) different scanning modes available.
An internal automatic antenna matches the transceiver to the connected antenna automatically. It can receive from 30 kHz up to 60 MHz continuously and transmit all mode, all bands with 100 watts RF. Dual Watch operation allows operator to monitor two frequencies in the same mode simultaneously. ICOM IC-756 Pro2 is popular HF+6m band transceiver. Set frequencies either by tuner dial or through direct entry by the keypad. Use remote jack for computer control and transceiver operation, Send/ALC jacks for non-Icom linear amplifier connections, external speaker jack, receive antenna jack, transverter jack and accessory sockets. This unit has an LCD display which shows multiple screen options including digital meter, spectrum scope, voice recorder, memory channels, scan, memory keyer, RTTY decorder, IF-filter selection, set various modes and much more! Two antenna ports on the rear panel, port 1 for 1.8-18 Mhz bands and port 2 for 21-50 Mhz bands. Accessories include, hand microphone (HM-36), and original instruction manual. Loaded with features, to many to discuss all of them here. This is the Icom IC 756 PRO II HF/50 Mhz all mode transceiver.